Whirlpool WRS325SDHZ08 Owner's Manual

The Whirlpool WRS325SDHZ08 is a 25 cubic foot side-by-side refrigerator with an ice and water dispenser, featuring Accu-Chill™ Temperature Management System, Adaptive Defrost, humidity-controlled crispers, gallon door bins, adjustable SpillGuard™ glass shelves, and factory-installed water filter. It is powered by 120V AC, 60Hz. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Supply 7. Using the Ice & Water Dispenser 8. Care & Cleaning 9. Replacing the Water Filter 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Side-by-side refrigerator/freezer, Electronic Controls, Ice and Water Dispenser, Accu-Chill™ Temperature Management System, Humidity-Controlled Crispers, SpillGuard™ Shelves, Gallon Door Bins.

Feature	Description
Accu-Chill™ System	Monitors and adjusts temperatures to keep food fresh
Adaptive Defrost	Adjusts defrost cycle based on usage to save energy
Humidity-Controlled Crispers	Seals in freshness for fruits and vegetables
SpillGuard™ Glass Shelves	Contain spills for easy cleanup
Gallon Door Bins	Store large containers in the door
Ice & Water Dispenser	Dispenses ice (crushed/cubed) and chilled water
Factory-Installed Water Filter	Filters water for dispenser and ice maker
Electronic Controls	Touchpad controls for temperature and features
Door Alarm	Sounds if door is left open
Power Cord	For electrical connection

Installation

Unpack and inspect contents. Ensure proper location with adequate clearance.

Remove packaging: Remove all tape, foam, and shipping materials.
Position refrigerator: Place on a level floor with at least 1" clearance on sides and top, 2" at back.
Connect water supply: Attach water line to shut-off valve and refrigerator inlet (see Section 7).
Plug into dedicated 120V AC outlet.
Allow 24 hours for cooling before adding food.

WARNING! Refrigerator is heavy; use two people to move. Ensure water connection is tight to prevent leaks.

First-Time Setup

Plug in refrigerator; follow initial setup steps.

Set temperatures: Use electronic controls to set fresh food and freezer compartments (recommended: 37°F fridge, 0°F freezer).
Dispense water: Flush system by dispensing 2-3 gallons of water to clear air and particles.
Enable ice maker: Lift wire signal arm to ON position.
Organize interior: Adjust shelves and bins as needed.

CAUTION! Do not use sharp objects to remove ice during initial cycles. Allow 24 hours for first ice production.

Specifications

Model: WRS325SDHZ08
Type: Side-by-Side Refrigerator/Freezer
Total Capacity: 25.0 cu. ft.
Fresh Food Capacity: 15.6 cu. ft.
Freezer Capacity: 9.4 cu. ft.
Ice Maker: Automatic with crushed/cubed selection
Water Filter: EveryDrop™ Ice & Water Filter EDR1RXD1 (factory installed)
Controls: Electronic touchpad with digital display
Defrost System: Adaptive Defrost
Power Source: 120V AC, 60Hz, 15A
Dimensions (HxWxD): 69-1/4" x 35-5/8" x 34-1/2"

Controls and Settings

Access controls via electronic touchpad on dispenser panel.

Control Panel: Power, Temperature Settings (Fridge/Freezer), Ice Type (Crushed/Cubed), Filter Reset, Door Alarm, Sabbath Mode, Lock Controls.

Temperature: Set fresh food (34°F to 46°F) and freezer (-5°F to 5°F). Ice Type: Select crushed or cubed ice. Filter Reset: Press and hold for 3 seconds after replacing filter. Door Alarm: Enable/disable alarm for open door. Sabbath Mode: Disables lights and alarms for religious observance. Lock Controls: Press and hold LOCK for 3 seconds to disable panel.

Connecting Water Supply

Required for ice maker and water dispenser.

Turn off main water supply.
Connect 1/4" copper or plastic water line to cold water shut-off valve.
Route line to refrigerator location (max length 20 ft).
Connect line to refrigerator water inlet valve at back (usually bottom left).
Turn on water and check for leaks.
Flush line before connecting to refrigerator.

Tip: Use a water line kit approved for refrigerators. Ensure connection is secure to prevent leaks.

Using the Ice & Water Dispenser

Dispenses ice (crushed or cubed) and chilled filtered water.

Select ice type: Press ICE TYPE button for crushed or cubed.
Dispense ice: Press glass against ice dispenser paddle.
Dispense water: Press glass against water dispenser paddle.
To stop: Remove glass from paddle.
Child Lock: Press and hold LOCK for 3 seconds to disable dispenser.

WARNING! Do not use without water filter installed. Keep children away from dispenser to avoid injury.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water; rinse and dry.

Exterior: Clean with soft cloth and mild detergent. Do not use abrasive cleaners.
Interior: Remove shelves and bins; wash in warm soapy water.
Dispenser: Wipe with damp cloth; clean ice bin monthly.
Condenser Coils: Vacuum every 6 months for efficiency.

CAUTION! Do not use harsh chemicals, ammonia, or bleach. Never clean glass shelves with hot water.

Replacing the Water Filter

Replace filter every 6 months or when indicator light turns on.

Locate filter: Inside refrigerator compartment, top left corner.
Turn filter counterclockwise to remove.
Insert new filter (EveryDrop™ EDR1RXD1); turn clockwise until it stops.
Flush system: Dispense 2-3 gallons of water.
Reset filter indicator: Press and hold FILTER RESET for 3 seconds.

Note: Use only Whirlpool-approved filters. Do not operate without a filter.

Regulatory Information

UL Listed; complies with NSF/ANSI Standard 42 for water filtration. Energy Star® certified. Copyright © Whirlpool Corporation. All trademarks owned by Whirlpool, U.S.A. For support, visit www.whirlpool.com or contact 1-800-253-1301.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Refrigerator not cooling	Power/controls	Ensure plugged in; check circuit breaker; verify temperature settings.
Water dispenser not working	Filter/water supply	Replace water filter; ensure water supply is on; check for kinks in line.
Ice maker not producing ice	Signal arm/filter	Ensure signal arm is down; replace water filter; allow 24 hours after setup.
Dispenser leaking	Glass alignment/connections	Ensure glass is centered under dispenser; check water line connections.
Unusual noises	Leveling/fan	Ensure refrigerator is level; check for obstructions in fan or condenser.

Reset: Unplug for 5 minutes, then plug back in.

Service: 1-800-253-1301; www.whirlpool.com