The Whirlpool WRS588FIHZ04 is a 25 cu. ft. French Door Refrigerator with an external ice and water dispenser, fingerprint-resistant stainless steel finish, adaptive defrost, adjustable gallon door bins, spill-proof glass shelves, humidity-controlled crispers, and a FreshFlow produce preserver. It features Accu-Chill temperature management, EveryDrop filtered water system, and LED lighting. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.
Key components: French doors, external ice and water dispenser, fingerprint-resistant stainless steel exterior, FreshFlow produce preserver, adaptive defrost system, LED interior lighting.
| Feature | Description |
|---|---|
| External Dispenser | Provides ice and filtered water without opening doors |
| FreshFlow Produce Preserver | Helps keep fruits and vegetables fresh longer |
| Accu-Chill Temperature Management | Maintains consistent temperatures for food preservation |
| EveryDrop Filtered Water System | Reduces contaminants for clean water and ice |
| Adjustable Gallon Door Bins | Hold large containers and can be repositioned |
| Spill-Proof Glass Shelves | Contain spills and are easy to clean |
| Humidity-Controlled Crispers | Customizable humidity settings for produce |
| Adaptive Defrost System | Optimizes defrost cycles for efficiency |
| LED Interior Lighting | Bright, energy-efficient illumination |
| Fingerprint-Resistant Finish | Reduces visible smudges and fingerprints |
Unpack and inspect contents. Ensure proper location and clearances.
WARNING! Refrigerator is heavy; use two people to move. Ensure water line connections are tight to prevent leaks.
After installation, follow these steps for initial operation.
CAUTION! Do not overload shelves. Allow space for air circulation inside compartments.
Control Panel: Located on the dispenser front. Includes temperature controls, filter reset, ice type selection, lock, and special modes.
Temperature Controls: Separate buttons for refrigerator and freezer temperatures (range: 33°F to 45°F for fridge, -5°F to 8°F for freezer).
Filter Reset Light: Indicates when to replace water filter (every 6 months). Press and hold FILTER RESET for 3 seconds after replacement.
Ice Type Selection: Choose between cubed or crushed ice via the ICE TYPE button.
Control Lock: Press and hold LOCK for 3 seconds to disable dispenser and controls.
Special Modes: Sabbath mode (disables lights and alarms), Max Cool (rapid cooling), and Vacation mode (sets fridge to energy-saving temperature).
For ice and water, press a glass against the dispenser pad.
Tip: Allow 24 hours for initial ice production. Discard first few batches.
Optimize organization with adjustable components.
WARNING! Do not place heavy items on door bins when fully extended. Ensure shelves are securely locked in place.
Unplug before cleaning interior. Use mild soap and water; avoid abrasive cleaners.
CAUTION! Do not use sharp objects to remove ice. Never use hot water on frozen surfaces.
UL Listed. Meets U.S. Department of Energy standards. Manufactured by Whirlpool Corporation. For support, visit www.whirlpool.com or contact 1-800-253-1301. Water filter certified by NSF International against standard 42 and 53. Copyright © 2025 Whirlpool Corporation. All rights reserved.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Refrigerator not cooling | Power/controls | Ensure unit is plugged in; check circuit breaker; verify temperature settings. |
| Dispenser not working | Lock/water supply | Disable control lock; check water supply valve; replace water filter. |
| Ice maker not producing ice | Water line/freezer temp | Ensure water line connected; freezer at 0°F; allow 24 hours after installation. |
| Water leaking inside | Drain clog | Check drain hole at back of fridge; clear with warm water. |
| Loud noises | Leveling/objects | Ensure refrigerator is level; check for items touching back wall. |
| Door not sealing | Gaskets/alignment | Clean door gaskets; check alignment; ensure nothing blocking closure. |
Reset: Unplug for 5 minutes, then plug back in to reset control board.
Service: 1-800-253-1301; www.whirlpool.com