Whirlpool Refrigerator WRS588FIHV00 Manual

The Whirlpool WRS588FIHV00 is a 25 cu. ft. French Door Refrigerator with external water and ice dispenser, fingerprint-resistant stainless steel finish, Adaptive Defrost, dual cooling systems, adjustable gallon door bins, humidity-controlled crispers, and LED lighting. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Line 7. Using the Dispenser 8. Temperature Management 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: French doors with external dispenser, adjustable interior shelves, humidity-controlled crispers, ice maker, water filter, and electronic controls.

Feature	Description
External Dispenser	Provides chilled water and ice (cubed or crushed)
Fingerprint-Resistant Finish	Stainless steel exterior that resists smudges
Adaptive Defrost	Adjusts defrost cycles based on usage to save energy
Dual Cooling Systems	Separate cooling for fridge and freezer compartments
Adjustable Gallon Door Bins	Bins can be repositioned to accommodate large containers
Humidity-Controlled Crispers	Preserve freshness of fruits and vegetables
LED Lighting	Energy-efficient interior lighting
Ice Maker	Produces ice automatically; includes off switch
Water Filter	Reduces contaminants; indicator light shows when to replace
Electronic Controls	Touch controls for temperature, dispenser, and features

Installation

Unpack and inspect contents. Ensure location meets clearance requirements.

Remove packaging: Take off all tape, foam, and cardboard.
Position refrigerator: Place on level floor with at least 1-inch clearance on sides and back, 2 inches at top.
Adjust leveling legs: Turn feet to level the refrigerator front-to-back and side-to-side.
Connect water line (optional): For ice/water dispenser, connect to cold water supply using copper or plastic tubing.
Plug into dedicated 120V AC outlet.

WARNING! Refrigerator is heavy; use two people to move. Ensure floor can support weight.

First-Time Setup

Plug in refrigerator; allow 24 hours for cooling before adding food.

Set temperatures: Use electronic controls to set fridge to 37°F (3°C) and freezer to 0°F (-18°C).
Enable ice maker: Lift wire signal arm to ON position; discard first two batches of ice.
Install water filter: Insert filter and flush system by dispensing 2 gallons of water.
Adjust shelves and bins: Configure interior to suit storage needs.

CAUTION! Do not overload shelves. Allow air circulation around food items.

Specifications

Capacity: 25 cubic feet total (17.5 cu. ft. fridge, 7.5 cu. ft. freezer).
Dimensions (HxWxD): 69.875" x 35.625" x 34.5".
Finish: Fingerprint-resistant stainless steel.
Dispenser Features: Water and ice (cubed/crushed) with lock option.
Cooling System: Dual evaporators with Adaptive Defrost.
Shelving: Tempered glass shelves, adjustable.
Energy Source: 120V AC, 60Hz, 7.5 amps.
Annual Energy Use: Approximately 685 kWh.
Water Filter: EveryDrop™ Filter 4 (model EDR4RXD1).

Controls and Settings

Access controls via touch panel on dispenser or inside fridge.

Dispenser Panel: Water/Crushed Ice/Cubed Ice buttons, Lock, Filter Reset, Temperature Settings.

Temperature: Set fridge (34°F–46°F) and freezer (-5°F to +5°F). Dispenser: Select water or ice type; press lock to disable. Filter Reset: Hold for 3 seconds after replacing filter. Special Modes: Sabbath Mode (disables lights and sounds), Vacation Mode (sets fridge to higher temp when away).

Connecting Water Line

Required for ice and water dispenser operation.

Turn off main water supply.
Connect approved tubing (1/4" OD) to cold water line using saddle valve or compression fitting.
Route tubing to refrigerator connection at bottom rear.
Connect tubing to refrigerator inlet valve; tighten by hand plus 1/4 turn with wrench.
Turn on water; check for leaks.
Flush system by dispensing 2 gallons of water.

Tip: Use copper or plastic tubing certified for potable water.

Using the Dispenser

Provides chilled water and ice at the door.

Select type: Press WATER, CUBED ICE, or CRUSHED ICE.
Dispense: Press glass against paddle or hold button.
Lock: Press LOCK to disable dispenser (indicator light on).
Change filter: When FILTER light turns yellow, replace filter and reset.
Clean exterior: Wipe with damp cloth; do not use abrasive cleaners.

WARNING! Do not use dispenser without water filter installed. Keep children away from dispenser mechanism.

Temperature Management

Maintain optimal temperatures for food safety.

Recommended: Fridge 37°F, Freezer 0°F. Adjust via controls. Adaptive Defrost: Runs only when needed. Dual Cooling: Prevents odor transfer. Crispers: Adjust humidity slider for fruits (low humidity) or vegetables (high humidity).

Care & Cleaning

Unplug before cleaning interior. Use mild soap and water; avoid abrasives.

Exterior: Wipe with stainless steel cleaner. Interior: Remove shelves and bins; wash with warm soapy water. Condenser coils: Vacuum every 6 months. Dispenser: Clean with vinegar solution if water flow decreases.

CAUTION! Do not use sharp objects to remove ice. Never steam clean.

Regulatory Information

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dispenser not working	Lock on/water filter	Check lock light; replace water filter; ensure water supply is on.
Ice maker not producing ice	Signal arm/temperature	Ensure signal arm is down; check freezer temperature is at or below 0°F.
Refrigerator not cooling	Power/controls	Check power cord; ensure temperature settings are correct; clean condenser coils.
Water leaking inside	Drain tube/clog	Check defrost drain for clog; clear with warm water.
Loud noises	Leveling/items touching	Ensure refrigerator is level; check for items touching back wall.

Reset: Unplug for 5 minutes, then plug back in.

Service: 1-800-253-1301; www.whirlpool.com