Whirlpool Refrigerator WRS325SDHZ08 User Manual

The Whirlpool WRS325SDHZ08 is a 25 cubic foot side-by-side refrigerator featuring an ice and water dispenser, adjustable spill-proof glass shelves, humidity-controlled crispers, gallon door bins, a freezer with storage baskets, and electronic temperature controls. It includes energy-saving modes, a door alarm, and a factory-set default temperature of 37°F for the fresh food compartment and 0°F for the freezer. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Using the Dispenser 7. Storage and Organization 8. Care & Cleaning 9. Energy Saving Tips 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Side-by-side doors, Ice and Water Dispenser, Electronic Controls, Adjustable Shelves, Humidity-Controlled Crispers, Freezer Baskets, Door Alarm.

FeatureDescription
Ice & Water DispenserProvides crushed or cubed ice and chilled water
Electronic ControlsDigital display for setting temperatures and modes
Spill-Proof Glass ShelvesAdjustable shelves that contain spills
Humidity-Controlled CrispersPreserve freshness of fruits and vegetables
Gallon Door BinsStore large containers and beverages
Freezer Storage BasketsOrganize frozen food items
Door Ajar AlarmAudible alert if door is left open
Energy Saver ModeReduces energy consumption
Factory ResetRestores default temperature settings
Power CordStandard 3-prong plug for 120V outlet

Installation

Unpack and inspect contents. Ensure proper clearance and leveling.

  1. Position the refrigerator: Allow at least 1 inch clearance on sides and back, 2 inches at top.
  2. Level the refrigerator: Adjust front leveling legs using a wrench.
  3. Connect to water line (for dispenser): Attach water supply line to shut-off valve and refrigerator inlet.
  4. Plug into a dedicated 120V AC outlet.
  5. Allow 24 hours for cooling before adding food.

WARNING! Refrigerator is heavy; use two people to move. Ensure water line connections are tight to prevent leaks.

First-Time Setup

Plug in the refrigerator; follow initial setup steps.

  1. Set temperatures: Press and hold TEMP buttons to set Fresh Food to 37°F and Freezer to 0°F.
  2. Dispenser setup: Flush water system for 3 minutes to clear air and particles.
  3. Enable features: Activate Door Alarm and Energy Saver via control panel if desired.
  4. Load food: After 24 hours, organize food on shelves and in bins.

CAUTION! Do not block air vents inside the refrigerator. Allow space for proper airflow.

Specifications

Controls and Settings

Access settings via the electronic control panel on the dispenser door.

Control Panel: TEMP (Fresh Food/Freezer), LOCK, ALARM, ENERGY SAVER, FILTER RESET, LIGHT.

Temperature: Set Fresh Food (34°F to 44°F) and Freezer (-5°F to 5°F). Door Alarm: Enable/disable audible alert. Control Lock: Locks dispenser and temperature buttons. Energy Saver: Reduces condensation in humid environments. Filter Reset: Resets indicator after filter replacement. Light: Turns interior lights on/off manually.

Using the Dispenser

Dispenser provides ice and chilled water.

  1. Select ice type: Press CRUSHED or CUBED button.
  2. Dispense ice: Press lever against glass.
  3. Dispense water: Press water button or lever.
  4. To turn off: Press and hold LOCK for 3 seconds.

Tip: First use may produce discolored ice; discard initial batches. Replace water filter every 6 months.

Storage and Organization

Optimize storage for efficiency and food preservation.

  1. Adjust shelves: Lift and reposition shelves to accommodate tall items.
  2. Crispers: Use humidity control slider for vegetables (HIGH) or fruits (LOW).
  3. Door bins: Store condiments, beverages, and gallon containers.
  4. Freezer baskets: Organize frozen foods by type for easy access.
  5. Do not overfill: Allow air circulation around items.

WARNING! Do not store glass containers in freezer if liquid-filled to prevent breakage.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water; avoid abrasives.

Exterior: Clean with soft cloth and stainless steel cleaner (if applicable). Interior: Remove shelves and bins; wash with soapy water. Dispenser: Wipe with damp cloth; clean ice bucket monthly. Condenser Coils: Vacuum every 6-12 months.

CAUTION! Do not use harsh chemicals, ammonia, or abrasive pads. Never steam clean.

Energy Saving Tips

Regulatory Information

UL Listed. Meets U.S. Department of Energy efficiency standards. This product contains R-600a refrigerant, which is flammable. Dispose of according to federal and local regulations. Copyright © Whirlpool Corporation. For support, visit www.whirlpool.com or contact 1-800-253-1301.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower/controlsEnsure plugged in; check circuit breaker; verify temperature settings.
Dispenser not workingLock/water supplyDisable Control Lock; ensure water line connected and valve open.
Water leakingWater line/ice makerTighten water line connections; check ice maker assembly for leaks.
Ice tastes or smells badWater filterReplace water filter; flush system after replacement.
Loud noisesLeveling/fanEnsure refrigerator is level; check for obstructions in fan.
Door alarm soundsDoor ajarClose door firmly; check for obstructions in door seal.

Reset: Unplug for 5 minutes, then plug back in to reset control board.

Service: 1-800-253-1301; www.whirlpool.com

Whirlpool Refrigerator WRS325SDHZ08 User Manual © - All Rights Reserved 2025