Whirlpool Refrigerator WRS325FDAW04 Manual

The Whirlpool WRS325FDAW04 is a 20.5 cubic foot side-by-side refrigerator with ice and water dispenser, featuring adjustable spill-proof glass shelves, humidity-controlled crispers, gallon door storage, and a factory-installed ice maker. It includes electronic temperature controls, a door alarm, and energy-saving modes. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Using the Dispenser 7. Care & Cleaning 8. Food Storage Tips 9. Energy Saving 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Side-by-side doors, Ice and Water Dispenser, Adjustable Glass Shelves, Humidity-Controlled Crispers, Gallon Door Bins, Factory-Installed Ice Maker, Electronic Controls.

FeatureDescription
Ice and Water DispenserProvides filtered ice and water through the door
Adjustable Glass ShelvesSpill-proof design; can be repositioned for flexibility
Humidity-Controlled CrispersPreserve freshness of fruits and vegetables
Gallon Door BinsStore large containers like milk jugs
Factory Ice MakerProduces ice automatically; no manual installation needed
Electronic Temperature ControlsDigital display for setting fridge and freezer temps
Door AlarmSounds if door is left open for extended period
Energy Saver ModeReduces power consumption when activated
Power FreezeTemporarily increases freezer cooling for new items
Power CoolTemporarily increases fridge cooling for new items

Installation

Unpack and inspect contents. Ensure location meets clearance requirements.

  1. Position refrigerator: Allow at least 1 inch clearance on sides and back for ventilation.
  2. Level the unit: Adjust front leveling legs to ensure doors close properly.
  3. Connect water line: For ice/water dispenser, connect to cold water supply using copper or plastic tubing.
  4. Plug into dedicated 120V AC outlet.
  5. Allow 24 hours for cooling before adding food.

WARNING! Refrigerator is heavy; use two people to move. Ensure water connection is tight to prevent leaks.

First-Time Setup

Plug in refrigerator; follow initial setup steps.

  1. Set temperatures: Use electronic controls to set fridge to 37°F (3°C) and freezer to 0°F (-18°C).
  2. Activate ice maker: Lift the wire signal arm to ON position.
  3. Flush water system: Dispense water for 3 minutes to clear air from lines.
  4. Load food: Allow temperatures to stabilize before adding perishables.

CAUTION! Do not block air vents inside with food items.

Specifications

Controls and Settings

Electronic controls located inside on ceiling of fresh food compartment.

Buttons: TEMPERATURE SET, LOCK, POWER FREEZE, POWER COOL, ENERGY SAVER, FILTER RESET.

Temperature Settings: Fresh Food (33°F to 45°F), Freezer (-5°F to 8°F). Lock Mode: Press and hold LOCK for 3 seconds to disable dispenser and controls. Filter Reset: Press FILTER RESET after replacing water filter. Energy Saver: Reduces condensation; use in low-humidity environments.

Using the Dispenser

Ice and water dispenser on front door.

  1. For water: Press glass against water paddle.
  2. For ice: Press glass against ice paddle (cubed or crushed if equipped).
  3. To change ice type: Press ICE TYPE button (if available).
  4. Child Lock: Press and hold LOCK for 3 seconds to disable dispenser.

Tip: First ice batch may take 24 hours. Discard initial ice.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water; rinse and dry.

  1. Exterior: Clean with soft cloth and mild cleaner. Avoid abrasives.
  2. Interior shelves/bins: Remove and wash with warm soapy water.
  3. Dispenser area: Wipe with damp cloth; clean ice bin monthly.
  4. Condenser coils: Vacuum every 6 months (located at back or bottom).

CAUTION! Do not use sharp objects to remove ice. Never use hot water on frozen surfaces.

Food Storage Tips

Energy Saving

Use ENERGY SAVER mode in low-humidity environments. Ensure door seals are clean and tight. Allow hot food to cool before storing. Keep condenser coils clean. Set temperatures to recommended levels.

Regulatory Information

UL Listed. Meets DOE energy efficiency standards. Copyright © Whirlpool Corporation. For support, visit www.whirlpool.com or contact 1-800-253-1301. Model WRS325FDAW04 serial number located on interior left wall.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower/controlsEnsure plugged in; check circuit breaker; verify temperature settings.
Water dispenser not workingFilter/water supplyReplace water filter; ensure water supply valve is open; flush system.
Ice maker not producing iceSignal arm/temperatureEnsure signal arm is down; freezer must be at 0°F; wait 24 hours.
Excessive frost in freezerDoor seal/usageCheck door seal for gaps; limit door openings; ensure food is covered.
Dispenser light not workingBulbReplace dispenser light bulb (consult manual for type).
Unusual noisesLeveling/fanEnsure refrigerator is level; check for items touching back wall; clean condenser fan.

Reset: Unplug for 5 minutes, then plug back in to reset electronic controls.

Service: 1-800-253-1301; www.whirlpool.com

Whirlpool Refrigerator WRS325FDAW04 Manual © - All Rights Reserved 2025