Whirlpool Refrigerator WRS325FDAM04 Manual

The Whirlpool WRS325FDAM04 is a 25 cubic foot side-by-side refrigerator with ice and water dispenser, adjustable spill-proof glass shelves, humidity-controlled crispers, gallon door bins, and a factory-installed water filter. It features electronic temperature controls, a Sabbath mode, and energy-saving options. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Using the Dispenser 7. Care & Cleaning 8. Replacing the Water Filter 9. Energy Saving Tips 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Side-by-side doors, Ice and Water Dispenser, Electronic Controls, Adjustable Shelves, Humidity-Controlled Crispers, Gallon Door Bins.

FeatureDescription
Ice & Water DispenserDispenses cubed ice and chilled water through the door
Adjustable Spill-Proof ShelvesGlass shelves that contain spills and can be repositioned
Humidity-Controlled CrispersPreserve freshness of fruits and vegetables
Gallon Door BinsStore large containers like milk jugs
Factory-Installed Water FilterFilters water for dispenser and ice maker (Filter 1)
Electronic ControlsTouchpad controls for temperature and features
Sabbath ModeDisables lights and dispenser for religious observance
Energy Saver ModeReduces energy consumption
Door AlarmSounds if door is left open
Power CordStandard 3-prong plug for 120V outlet

Installation

Unpack and inspect contents. Remove all packaging materials and tape.

  1. Position the refrigerator: Allow at least 1 inch clearance on sides and back for ventilation.
  2. Level the refrigerator: Adjust the front leveling legs so doors close properly.
  3. Connect to water line: Shut off water supply, connect 1/4" copper tubing to water valve.
  4. Plug into a dedicated 120V, 15-amp grounded electrical outlet.
  5. Turn on water supply and check for leaks at connections.

WARNING! Refrigerator is heavy; use two people to move. Ensure it is level to prevent door alignment issues.

First-Time Setup

Plug in the refrigerator; allow 24 hours for temperatures to stabilize.

  1. Set temperatures: Press and hold TEMP buttons to set Fresh Food (recommended 37°F) and Freezer (recommended 0°F).
  2. Enable ice maker: Lift the wire signal arm to ON position.
  3. Flush the water system: Dispense and discard 2-3 gallons of water through the dispenser.
  4. Load food: Do not overload shelves; allow air circulation.

CAUTION! Do not use mechanical devices to defrost. Keep ventilation openings clear.

Specifications

Controls and Settings

Access controls via the touchpad on the dispenser panel.

Touchpad Buttons: LIGHT, LOCK, TEMP (Fresh Food/Freezer), FILTER RESET, ENERGY SAVER, SABBATH, CRUSHED ICE, WATER, CUBED ICE.

Temperature Settings: Press and hold TEMP buttons to adjust. Default: Fresh Food 37°F, Freezer 0°F. Filter Reset: Press and hold for 3 seconds after replacing filter. Energy Saver: Press to reduce condensation. Sabbath Mode: Press and hold for 3 seconds to disable lights and dispenser for 72 hours. Door Alarm: Sounds after 3 minutes if door is ajar; press any button to silence.

Using the Dispenser

Dispenses cubed ice, crushed ice, and chilled water.

  1. Select ice type: Press CRUSHED ICE or CUBED ICE button.
  2. Dispense ice: Press glass against the ice paddle.
  3. Dispense water: Press glass against the water paddle.
  4. Lock dispenser: Press and hold LOCK for 3 seconds to disable (prevents accidental activation).

Tip: First use may take 24 hours for ice production. Discard first few batches.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water; rinse and dry.

  1. Exterior: Clean with soft cloth and mild detergent. Do not use abrasive cleaners.
  2. Interior shelves and bins: Remove and wash with warm soapy water.
  3. Dispenser area: Wipe with damp cloth; clean ice chute with warm water.
  4. Condenser coils: Vacuum every 6 months to maintain efficiency.

CAUTION! Do not use harsh chemicals, ammonia, or wax on surfaces.

Replacing the Water Filter

Replace filter every 6 months or when indicator light comes on.

  1. Locate filter: Inside the refrigerator compartment, upper left corner.
  2. Turn filter counterclockwise to remove; discard old filter.
  3. Insert new filter (EveryDrop™ Filter 1); turn clockwise until it stops.
  4. Flush system: Dispense 2-3 gallons of water and discard.
  5. Reset filter indicator: Press and hold FILTER RESET for 3 seconds.

WARNING! Do not use without a filter. Use only approved replacement filters.

Energy Saving Tips

Regulatory Information

UL Listed. Meets U.S. Department of Energy energy efficiency standards. Copyright © Whirlpool Corporation. For support, visit www.whirlpool.com or contact 1-800-253-1301. This product contains fluorinated greenhouse gases covered by the Kyoto Protocol.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower/controlsEnsure plugged in; check circuit breaker; verify temperature settings.
Dispenser not workingLock/water supplyCheck if dispenser is locked; ensure water supply is on and filter not clogged.
Ice maker not making iceSignal arm/filterEnsure signal arm is down; replace water filter; allow 24 hours for production.
Water leakingConnections/defrostTighten water line connections; check defrost drain for clog.
Noisy operationLeveling/fanEnsure refrigerator is level; check for items touching back wall; clean condenser fan.

Reset: Unplug for 5 minutes, then plug back in.

Service: 1-800-253-1301; www.whirlpool.com

Whirlpool Refrigerator WRS325FDAM04 Manual © - All Rights Reserved 2025