Whirlpool Refrigerator WRS325FDAB06 Manual

The Whirlpool WRS325FDAB06 is a 25 cubic foot French Door Refrigerator with external ice and water dispenser, fingerprint-resistant stainless steel finish, Accu-Chill™ temperature management system, FreshFlow™ produce preserver, humidity-controlled crispers, gallon door bins, adjustable spill-proof glass shelves, and LED lighting. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Using the Dispenser 7. Storage Features 8. Care & Cleaning 9. Energy Saving Tips 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: French doors, external ice and water dispenser, digital controls, adjustable interior features, and energy-efficient design.

FeatureDescription
Accu-Chill™ Temperature ManagementMaintains consistent temperature for food freshness
FreshFlow™ Produce PreserverHelps keep fruits and vegetables fresh longer
Humidity-Controlled CrispersAdjustable vents to control moisture for produce
External Ice & Water DispenserDispenses filtered water and ice without opening doors
Adjustable Spill-Proof Glass ShelvesEasy to clean and reposition for flexible storage
Gallon Door BinsHold large containers like milk jugs
Fingerprint-Resistant Stainless SteelEasy to clean and resists smudges
LED Interior LightingBright, energy-efficient lighting
Energy Star® CertifiedMeets energy efficiency guidelines
Door AlarmAlerts if door is left open

Installation

Unpack and inspect contents. Ensure proper location and clearances.

  1. Remove packaging: Take off all tape, foam, and protective film.
  2. Position refrigerator: Place on level floor with at least 2 inches clearance at back and sides.
  3. Connect water line: For ice maker and water dispenser, connect to cold water supply using copper or plastic tubing.
  4. Plug into dedicated 115V, 60Hz, 15-amp grounded outlet.
  5. Allow 24 hours for cooling before adding food.

WARNING! Heavy appliance; use two people to move. Ensure water line connection is tight to prevent leaks.

First-Time Setup

Plug in refrigerator; follow initial setup steps.

  1. Set temperature: Press TEMP buttons to set refrigerator to 37°F (3°C) and freezer to 0°F (-18°C).
  2. Enable ice maker: Lift wire signal arm to ON position.
  3. Flush water system: Dispense and discard first 2 gallons of water to clear air from lines.
  4. Adjust shelves and bins: Configure interior for your storage needs.
  5. Set door alarm: Enable in control panel if desired.

CAUTION! Do not overload shelves. Allow space for air circulation.

Specifications

Controls and Settings

Digital control panel located on dispenser front.

Controls: TEMP buttons (fridge/freezer), LOCK button (control lock), FILTER RESET, LIGHT button (interior LED), ALARM button (door alarm).

Temperature Settings: Refrigerator (34-46°F), Freezer (-6 to 6°F). Control Lock: Press and hold LOCK for 3 seconds to disable panel. Filter Reset: Press FILTER RESET after replacing water filter. Door Alarm: Sounds after 3 minutes if door is ajar.

Using the Dispenser

External dispenser provides ice and filtered water.

  1. Water: Press glass against water paddle. Release to stop.
  2. Ice: Press glass against ice paddle. Select crushed or cubed ice using switch.
  3. Child Lock: Press and hold LOCK for 3 seconds to disable dispenser.
  4. Filter Status: FILTER light indicates when to replace (every 6 months).

Tip: First ice production may take 24 hours. Discard first batch.

Storage Features

Optimize organization for freshness and convenience.

  1. Crispers: Use humidity control - high for vegetables, low for fruits.
  2. Shelves: Adjust height by lifting front and repositioning.
  3. Door Bins: Store condiments, beverages. Gallon bins hold large containers.
  4. Freezer Baskets: Slide-out for easy access to frozen foods.
  5. Meat Drawer: Keep meats in original packaging on lowest shelf.

WARNING! Do not block air vents. Keep food wrapped to prevent odors.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water.

  1. Exterior: Clean with stainless steel cleaner and soft cloth.
  2. Interior: Remove shelves and bins; wash with warm soapy water.
  3. Dispenser: Wipe with damp cloth; clean ice bucket monthly.
  4. Condenser Coils: Vacuum every 6 months for efficiency.
  5. Water Filter: Replace every 6 months or when FILTER light comes on.

CAUTION! Do not use abrasive cleaners. Never use hot water on cold glass shelves.

Energy Saving Tips

  1. Maintain temperatures: 37°F refrigerator, 0°F freezer.
  2. Ensure door seals are clean and tight.
  3. Allow hot foods to cool before refrigerating.
  4. Keep condenser coils clean.
  5. Minimize door openings.
  6. Use energy-saving mode if available.

Regulatory Information

UL Listed. Energy Star® Certified. FCC Part 15 compliant. Manufactured for household use. For service, contact Whirlpool Customer Service at 1-800-253-1301 or visit www.whirlpool.com. Serial number located on interior left wall. Keep receipt for warranty service.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower/controlsCheck power cord; ensure temperature set correctly; clean condenser coils.
Water dispenser not workingFilter/water supplyReplace water filter; check water supply valve; flush system.
Ice maker not producing iceArm position/temperatureEnsure signal arm is down; freezer must be at 0°F; wait 24 hours.
Excessive frost in freezerDoor seal/usageCheck door seal; minimize door openings; do not overload.
Dispenser leakingGlass positioningEnsure glass is centered on paddle; check water line connections.
Unusual noisesLeveling/fanLevel refrigerator; check for items touching back wall; normal fan sounds occur.

Reset: Unplug for 5 minutes, then plug back in.

Service: 1-800-253-1301; www.whirlpool.com

Whirlpool Refrigerator WRS325FDAB06 Manual © - All Rights Reserved 2025