Whirlpool Refrigerator WRF767SDHZ04 Manual

The Whirlpool WRF767SDHZ04 is a 36-inch French Door Refrigerator with a capacity of 27.2 cubic feet, featuring external water and ice dispenser, adaptive defrost, dual cooling systems, adjustable gallon door bins, humidity-controlled crispers, LED lighting, and a fingerprint-resistant stainless steel finish. It includes energy-saving modes, door alarm, and a factory-set temperature of 37°F for the fresh food compartment and 0°F for the freezer. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Using the Dispenser 7. Storage Features 8. Care & Cleaning 9. Energy Saving Tips 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: French doors with external dispenser, adjustable interior shelves, humidity-controlled crispers, ice maker, water filter, and electronic controls.

FeatureDescription
External DispenserProvides filtered water and ice (cubed or crushed)
Adaptive Defrost SystemReduces energy use by defrosting only when needed
Dual Cooling SystemsSeparate cooling for fridge and freezer to preserve freshness
Adjustable Gallon Door BinsHold large containers; can be repositioned or removed
Humidity-Controlled CrispersPreserve produce freshness with adjustable vents
LED Interior LightingEnergy-efficient, bright illumination
Fingerprint-Resistant FinishStainless steel exterior that resists smudges
Door AlarmSounds if door is left open for more than 5 minutes
Energy Saver ModeReduces condensation in humid environments
Ice MakerProduces up to 5.5 lbs of ice per day

Installation

Unpack and inspect contents. Ensure location meets clearance requirements.

  1. Position refrigerator: Allow at least 1 inch of space on sides and back, 2 inches at top for ventilation.
  2. Level the refrigerator: Adjust front leveling legs using a wrench to ensure doors close properly.
  3. Connect water line: For ice/water dispenser, connect to a cold water line with 1/4" copper tubing.
  4. Plug into dedicated 115V, 15-amp grounded outlet.
  5. Install water filter: Insert filter (EveryDrop® Filter 4) and flush 2 gallons to remove air.

WARNING! Refrigerator is heavy; use two people to move. Do not use extension cord.

First-Time Setup

After installation, allow 24 hours for temperature stabilization.

  1. Set temperatures: Fresh food compartment default is 37°F; freezer default is 0°F. Adjust via control panel.
  2. Enable ice maker: Lift wire signal arm to ON position. First batch may take 24 hours.
  3. Select modes: Press and hold ENERGY SAVER for 3 seconds to activate in humid environments.
  4. Test door alarm: Leave door open for 5 minutes to confirm alarm sounds.

CAUTION! Do not load food until temperatures are stable. Keep doors closed during stabilization.

Specifications

Controls and Settings

Control panel located above dispenser. Buttons: TEMPERATURE SET, ICE TYPE, LOCK, ENERGY SAVER, FILTER RESET.

Temperature Settings: Press TEMPERATURE SET, then use arrows for fridge (34-46°F) or freezer (-6 to 6°F). Ice Type: Press to toggle between cubed and crushed. Control Lock: Press and hold LOCK for 3 seconds to disable panel. Energy Saver: Reduces condensation. Filter Reset: Press after replacing water filter.

Interior: Adjust shelves by lifting and repositioning. Crisper humidity: Slide vent open for low humidity, closed for high.

Using the Dispenser

Dispenser provides water and ice without opening doors.

  1. Select ice type: Press ICE TYPE for cubed or crushed.
  2. For water: Press glass against water paddle. Release to stop.
  3. For ice: Press glass against ice paddle. Use gentle pressure.
  4. To turn off ice/water: Press and hold ICE TYPE and WATER simultaneously for 3 seconds.

Tip: First use may dispense discolored water; flush 2 gallons. Replace filter every 6 months.

Storage Features

Optimize organization for efficiency.

WARNING! Do not overload shelves. Distribute weight evenly.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water; avoid abrasives.

  1. Exterior: Wipe with damp cloth; use stainless steel cleaner for finish.
  2. Interior: Remove shelves and bins; wash with soapy water. Dry thoroughly.
  3. Dispenser: Wipe area with soft cloth; clean drip tray regularly.
  4. Condenser coils: Vacuum every 6 months (located at rear bottom).

CAUTION! Do not use harsh chemicals, ammonia, or steel wool. Never clean ice maker with water.

Energy Saving Tips

Regulatory Information

UL Listed. Meets DOE energy efficiency standards. This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. Refrigerant: R-600a (isobutane), a flammable gas. For disposal, contact authorized service. Copyright © Whirlpool Corporation. For support, visit www.whirlpool.com or contact 1-800-253-1301.

Troubleshooting

SymptomPossible CauseCorrective Action
Dispenser not workingControl lock/water supplyDisable control lock; ensure water line is on and filter installed.
Ice maker not producing iceSignal arm/freezer tempEnsure signal arm is down; freezer must be at 0°F; allow 24 hours.
Refrigerator is warmPower/temp settingsCheck if plugged in; ensure temp settings are correct; clean condenser coils.
Water tastes badOld filterReplace water filter; flush system.
Excessive frost in freezerDoor seal/defrost systemCheck door seal for gaps; ensure defrost system is functioning.
Loud noisesLeveling/objects nearbyLevel refrigerator; ensure nothing is touching back or sides.

Reset: Unplug for 5 minutes, then plug back in to reset electronic controls.

Service: 1-800-253-1301; www.whirlpool.com

Whirlpool Refrigerator WRF767SDHZ04 Manual © - All Rights Reserved 2025