Whirlpool Refrigerator WRF767SDHZ Manual

The Whirlpool WRF767SDHZ is a 36-inch French Door Refrigerator with 26.2 cubic feet capacity, featuring external water and ice dispenser, Adaptive Defrost, dual evaporators, FreshFlow® produce preserver, humidity-controlled crispers, LED lighting, Accu-Chill™ temperature management system, and factory-installed ice maker. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Line 7. Using the Dispenser 8. Care & Cleaning 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: French doors, external ice and water dispenser, adjustable gallon door bins, humidity-controlled crispers, FreshFlow® filter, dual cooling systems.

Feature	Description
External Dispenser	Ice and chilled water access without opening doors
Adaptive Defrost	Adjusts defrost cycle based on usage for efficiency
FreshFlow® Produce Preserver	Helps keep fruits and vegetables fresh longer
Humidity-Controlled Crispers	Adjustable vents to control moisture for produce
Accu-Chill™ System	Monitors and adjusts temperatures for consistent cooling
LED Lighting	Energy-efficient interior lighting
Dual Evaporators	Separate cooling systems for fridge and freezer
Factory Ice Maker	Produces ice automatically; connects to water line
Adjustable Door Bins	Can hold gallon-sized containers
Energy Star® Certified	Meets energy efficiency guidelines

Installation

Unpack and inspect contents. Ensure proper location with adequate clearance.

Remove packaging: Take off all tape, foam, and protective film.
Position refrigerator: Allow 1-inch clearance on sides and back, 2-inch top clearance for ventilation.
Level the unit: Adjust front leveling legs using a wrench for stability.
Connect water line: Use ¼-inch copper tubing or FDA-approved plastic line to water supply.
Plug into dedicated 115V, 60Hz AC outlet.

WARNING! Refrigerator is heavy; use two people for moving. Ensure floor can support weight.

First-Time Setup

Plug in refrigerator; allow 24 hours for cooling before adding food.

Set temperatures: Use control panel to set fridge to 37°F (3°C) and freezer to 0°F (-18°C).
Flush water system: Dispense 2-3 gallons of water to clear air and particles from new lines.
Install FreshFlow® filter: Remove cap, insert filter, run water for 5 minutes to activate.
Adjust shelves and bins: Configure interior to suit storage needs.

CAUTION! Do not block air vents inside refrigerator. Allow space for air circulation.

Specifications

Model: WRF767SDHZ
Type: French Door Refrigerator
Total Capacity: 26.2 cu. ft. (Refrigerator: 17.5 cu. ft., Freezer: 8.7 cu. ft.)
Dimensions (HxWxD): 70.125" x 35.75" x 35.625"
Water Filter: EveryDrop® Ice & Water Filter EDR4RXD1 (replaces every 6 months)
Dispenser Features: Ice (crushed/cubed), chilled water, lock option
Defrost System: Adaptive automatic defrost
Power Requirements: 115V, 60Hz, 7.5A
Energy Star: Yes
Finish: Stainless steel

Controls and Settings

Control Panel located on front dispenser area.

Buttons: TEMPERATURE (Fridge/Freezer), ICE TYPE (Crushed/Cubed), LOCK, FILTER RESET, LIGHT, ALARM RESET.

Temperature Settings: Fridge 34-46°F (1-8°C), Freezer -6 to 6°F (-21 to -14°C). Dispenser Lock: Press and hold LOCK for 3 seconds to disable dispenser. Filter Indicator: Flashes when filter needs replacement; press FILTER RESET for 3 seconds after changing. Door Alarm: Sounds if door left open >5 minutes; press ALARM RESET to silence.

Connecting Water Line

Required for ice maker and water dispenser.

Turn off main water supply.
Connect ¼-inch water line to cold water pipe using saddle valve or compression fitting.
Route line to refrigerator connection at bottom rear (avoid kinks).
Connect line to refrigerator inlet valve; tighten by hand plus ¼ turn with wrench.
Turn on water; check for leaks at all connections.

Tip: Use manufacturer-recommended water line. Do not use plastic tubing not rated for pressure.

Using the Dispenser

Provides ice and chilled water.

Activate: Press glass against dispenser pad or press lever.
Select ice type: Press ICE TYPE to toggle between cubed and crushed.
Stop: Remove glass or release lever.
Dispenser lock: Press and hold LOCK button for 3 seconds to enable/disable.
First ice: May take 24 hours after installation to produce first batch.

WARNING! Do not use dispenser without water line connected. Keep children away from dispenser lever.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water; avoid abrasive cleaners.

Exterior: Wipe stainless steel with grain using manufacturer-approved cleaner. Interior: Remove shelves and bins; wash with soapy water. Condenser coils: Vacuum every 6-12 months (located at back or bottom front grille).

CAUTION! Do not use sharp objects to remove ice. Never clean with flammable fluids.

Regulatory Information

UL Listed; meets NSF/ANSI Standard 7 for commercial refrigerators. Energy Star Partner. For support, visit www.whirlpool.com or contact 1-800-253-1301. This product contains refrigerants that must be disposed of by EPA-certified technicians.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Refrigerator not cooling	Power/controls	Ensure plugged in; check circuit breaker; verify temperature settings.
Dispenser not working	Water line/lock	Check water supply valve; ensure line not kinked; disable dispenser lock.
Ice maker not producing	Filter/temperature	Replace water filter; ensure freezer temperature at 0°F or below.
Water leaking inside	Drain clog	Clear defrost drain tube at back of fridge interior.
Loud noises	Leveling/fan	Level refrigerator; check for objects touching condenser fan.

Reset: Unplug for 5 minutes, then plug back in to reset control board.

Service: 1-800-253-1301; www.whirlpool.com