Whirlpool Refrigerator WRF736SDAM13 Manual

The Whirlpool WRF736SDAM13 is a 36-inch French Door Refrigerator with 25.5 cubic feet capacity, featuring external ice and water dispenser, adaptive defrost, dual cooling systems, adjustable gallon door bins, humidity-controlled crispers, LED lighting, and factory-installed water filter. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: French doors with external dispenser, adjustable interior shelves, humidity-controlled crispers, ice maker, water filter system.

Installation

Unpack and inspect contents. Ensure proper location and clearances.

1. Remove packaging: Take off all tape, foam, and shipping materials.
2. Position refrigerator: Allow at least 1 inch clearance on sides and back for ventilation.
3. Level the unit: Adjust front leveling legs to ensure doors close properly.
4. Connect water line: Attach to cold water supply using copper or plastic tubing.
5. Plug into dedicated 115V, 15-20 amp grounded outlet.

WARNING! Refrigerator is heavy; use two people for moving. Ensure water connection is tight to prevent leaks.

First-Time Setup

After installation, allow refrigerator to stabilize before loading food.

1. Power on: Plug in unit; interior lights should illuminate.
2. Set temperatures: Use electronic controls to set fridge to 37°F and freezer to 0°F.
3. Flush water system: Dispense and discard first 2 gallons of water to clear air.
4. Allow cooling: Let unit run for 24 hours before adding food for optimal performance.
5. Activate ice maker: Lift signal arm to begin ice production cycle.

CAUTION! Do not overload shelves. Allow air circulation around items.

Specifications

• Model: WRF736SDAM13
• Type: French Door Refrigerator with Bottom Freezer
• Total Capacity: 25.5 cubic feet
• Refrigerator Capacity: 17.5 cubic feet
• Freezer Capacity: 8.0 cubic feet
• Dimensions (HxWxD): 69.875" x 35.625" x 34.5"
• Water Filter: EveryDrop™ Filter 4 (EDR4RXD1)
• Defrost System: Adaptive Defrost
• Power Requirements: 115V, 60Hz, 7.5 amps
• Energy Star Certified: Yes

Controls and Settings

Electronic controls located inside refrigerator compartment.

Control Panel: Temperature display, Fridge/Freezer adjustment buttons, Filter Reset, Light, Lock, and Alarm buttons.

Temperature Settings: Fridge range 34°F to 46°F; Freezer range -5°F to 5°F. Filter Reset: Press and hold for 3 seconds after filter replacement. Door Alarm: Sounds after 3 minutes if door is ajar; press Alarm button to silence. Control Lock: Prevents accidental setting changes; press and hold Lock for 3 seconds.

Using the Dispenser

External dispenser provides ice and chilled water.

1. Activate dispenser: Press glass against water paddle or press ice button.
2. Select ice type: Cubed or crushed (if equipped).
3. Water dispensing: Hold glass against paddle; water flows automatically.
4. To stop: Remove glass or press Cancel button.
5. Child lock: Press and hold Lock button for 3 seconds to disable dispenser.

Tip: First-time use may take 24 hours for ice production. Discard first batch.

Temperature Management

Optimal food preservation requires proper temperature settings.

1. Recommended settings: Fridge 37°F, Freezer 0°F.
2. Adjusting temperatures: Use + and - buttons on control panel.
3. Allow stabilization: Wait 24 hours after adjustment before checking.
4. Use thermometer: Place in fridge/freezer to verify accuracy.
5. Seasonal adjustments: May need cooler settings in summer months.

WARNING! Do not block air vents inside compartments. Keep food items away from temperature sensors.

Care & Cleaning

Regular maintenance ensures optimal performance and longevity.

1. Exterior: Clean with mild detergent and soft cloth; avoid abrasives.
2. Interior: Remove shelves and bins; wash with warm soapy water.
3. Dispenser area: Wipe with damp cloth; clean ice bucket monthly.
4. Condenser coils: Vacuum every 6 months (located at back or bottom).
5. Door seals: Clean with baking soda solution; check for proper seal.

CAUTION! Unplug before cleaning interior. Never use sharp objects to remove ice.

Filter Replacement

Replace water filter every 6 months for optimal performance.

1. Locate filter: Inside refrigerator compartment, upper right corner.
2. Turn off water: Shut off water supply valve.
3. Remove old filter: Turn counterclockwise; pull straight out.
4. Insert new filter: Align arrows; turn clockwise until it stops.
5. Reset filter indicator: Press and hold Filter Reset for 3 seconds.
6. Flush system: Dispense 2 gallons of water; discard first batch of ice.

Note: Use only EveryDrop™ Filter 4 (EDR4RXD1) for proper fit and filtration.

Regulatory Information

UL Listed: Complies with UL Standard 250. FCC Part 15: Class B digital device. Energy Star: Meets EPA energy efficiency guidelines. California Proposition 65 Warning: Contains chemicals known to cause cancer and reproductive harm. For support, visit www.whirlpool.com or contact 1-800-253-1301. Serial and model numbers located on interior left wall.

Troubleshooting

Reset: Unplug for 5 minutes, then replug to reset electronic controls.

Service: 1-800-253-1301; www.whirlpool.com