Whirlpool Refrigerator Manual WRS571CIHZ01

The Whirlpool WRS571CIHZ01 is a 21.5 cubic foot French Door Refrigerator with an external water and ice dispenser, fingerprint-resistant stainless steel finish, Accu-Chill™ temperature management system, FreshFlow™ air filter, adjustable gallon door bins, humidity-controlled crispers, and LED lighting. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Line 7. Using the Dispenser 8. Food Storage Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: French doors with external dispenser, electronic controls, adjustable interior shelves, humidity-controlled crispers, ice maker, and water filter.

Feature	Description
Accu-Chill™ Temperature Management	Monitors and adjusts temperatures to keep food fresh
FreshFlow™ Air Filter	Reduces odors to keep food tasting fresh
External Water & Ice Dispenser	Provides chilled water and ice without opening doors
Fingerprint-Resistant Stainless Steel	Easy-to-clean exterior finish
Adjustable Gallon Door Bins	Hold large containers and gallon-sized beverages
Humidity-Controlled Crispers	Preserve freshness of fruits and vegetables
LED Interior Lighting	Energy-efficient, bright illumination
Ice Maker	Produces ice automatically; indicator light shows when bin is full
Door Alarm	Sounds if door is left open for an extended period
Energy Star® Certified	Meets energy efficiency guidelines

Installation

Unpack and inspect contents. Ensure proper clearance and leveling.

Remove packaging: Take off all tape, foam, and protective film.
Position refrigerator: Allow at least 1 inch clearance on sides and back, 2 inches at top for ventilation.
Level the unit: Adjust front leveling legs so refrigerator is stable and doors close properly.
Connect water line (optional): For ice/water dispenser, connect to cold water supply using approved tubing.
Plug into dedicated 120V AC, 60Hz outlet.

WARNING! Refrigerator is heavy; use two people to move. Ensure it is level to prevent door issues.

First-Time Setup

Plug in refrigerator; allow 24 hours for temperatures to stabilize.

Set temperatures: Use control panel to set refrigerator to 37°F (3°C) and freezer to 0°F (-18°C).
Install water filter: Insert and flush filter per instructions if using dispenser.
Enable ice maker: Lift the wire signal arm to start ice production.
Organize interior: Adjust shelves and bins to suit storage needs.

CAUTION! Do not load food until temperatures are stable. Keep doors closed during initial cool-down.

Specifications

Capacity: 21.5 cubic feet total (14.7 cu ft refrigerator, 6.8 cu ft freezer).
Dimensions (HxWxD): 69.875" x 35.625" x 34.5".
Door Style: French doors with bottom freezer drawer.
Finish: Fingerprint-resistant stainless steel.
Dispenser: External water and ice (cubed).
Temperature Controls: Electronic with digital display.
Filter: EveryDrop™ Ice & Water Filter EDR1RXD1 (replaces every 6 months).
Power Source: 120V AC, 60Hz, 6.5 Amps.
Annual Energy Use: 608 kWh (ENERGY STAR® certified).

Controls and Settings

Access controls via front display panel. Buttons: TEMPERATURE, FILTER, LOCK, ICE TYPE, LIGHT.

Temperature Settings: Press TEMPERATURE to adjust fridge/freezer temps. Display shows current settings.

Filter Reset: Press and hold FILTER for 3 seconds after replacing filter to reset indicator.

Control Lock: Press and hold LOCK for 3 seconds to prevent accidental changes.

Ice Type: Press ICE TYPE to select cubed or crushed ice (if equipped).

Interior Light: Press LIGHT to turn LED lights on/off manually.

Connecting Water Line

For ice and water dispenser operation.

Turn off main water supply and unplug refrigerator.
Connect 1/4" copper or plastic tubing to cold water line using a saddle valve or tee fitting.
Run tubing to refrigerator connection at bottom rear; avoid kinks.
Connect tubing to inlet valve; tighten compression nut.
Turn on water; check for leaks. Flush system for 3 minutes.
Plug in refrigerator and enable ice maker.

Tip: Use an approved water filter to improve taste and reduce sediment.

Using the Dispenser

Provides chilled water and ice without opening doors.

Water: Press a glass against the water paddle. Release to stop.
Ice: Press glass against ice paddle (select cubed or crushed first if equipped).
To dispense without a glass: Press and hold the paddle manually.
Ice Maker: Signal arm up = ice production on; arm down = off. Empty bin when full indicator lights.

WARNING! Do not use with containers that cannot be easily removed. Keep area clean to prevent mold.

Food Storage Features

Adjustable shelves, humidity crispers, door bins.

Crispers: Use high humidity for vegetables, low for fruits.

Shelves: Adjust height or remove for cleaning.

Door Bins: Adjustable to hold gallon containers.

Meat Drawer (if equipped): Keep meat at consistent temperature.

FreshFlow™ Filter: Replace every 6 months to reduce odors.

Care & Cleaning

Unplug before cleaning interior. Use mild soap and water; avoid abrasives.

Exterior: Wipe with damp cloth; use stainless steel cleaner for finish.

Interior: Remove shelves and bins; wash with warm, soapy water.

Dispenser: Wipe with clean cloth; run water through to flush.

Condenser Coils: Vacuum every 6 months for efficiency.

CAUTION! Do not use harsh chemicals, ammonia, or steam cleaners. Never clean ice maker with sharp objects.

Regulatory Information

Troubleshooting

Symptom	Possible Cause	Corrective Action
Refrigerator not cooling	Power/controls	Ensure plugged in; check circuit breaker; verify temperature settings.
Dispenser not working	Water supply/filter	Check water line connection; replace water filter; ensure water valve is on.
Ice maker not making ice	Signal arm/filter	Ensure signal arm is up; check water supply; replace filter if clogged.
Water leaking on floor	Line connections/defrost	Tighten water line connections; check defrost drain for clog.
Loud noises	Leveling/fan	Ensure refrigerator is level; check for obstructions in fan or compressor area.
Door not sealing	Leveling/gaskets	Adjust leveling legs; clean door gaskets; ensure nothing blocking closure.

Reset: Unplug for 5 minutes, then plug back in to reset electronic controls.

Service: 1-800-253-1301; www.whirlpool.com