Whirlpool Model WRS321SDHW01 Manual

The Whirlpool Model WRS321SDHW01 is a 21.6 cubic foot side-by-side refrigerator with ice and water dispenser, adaptive defrost system, spill-proof glass shelves, humidity-controlled crispers, gallon door bins, and factory-installed water filter (WFC7500). It features adjustable temperature controls, energy-saving mode, door alarm, and a sleek stainless steel finish. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Line 7. Using Ice & Water Dispenser 8. Care & Cleaning 9. Energy Saving Tips 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Side-by-side refrigerator/freezer, Ice and Water Dispenser, Adaptive Defrost System, Spill-Proof Glass Shelves, Humidity-Controlled Crispers, Gallon Door Bins, Factory-Installed Water Filter.

FeatureDescription
Ice and Water DispenserDispenses ice (cubed/crushed) and chilled water through door
Adaptive Defrost SystemOptimizes defrost cycles for energy efficiency
Spill-Proof Glass ShelvesContain spills for easy cleanup
Humidity-Controlled CrispersPreserve freshness of fruits and vegetables
Gallon Door BinsStore large containers like milk jugs
Factory-Installed Water FilterFilters water for dispenser and ice maker (Model WFC7500)
Adjustable Temperature ControlsSeparate controls for refrigerator and freezer sections
Door AlarmSounds if door is left open for extended period
Energy-Saving ModeReduces energy consumption when activated
Stainless Steel FinishDurable, fingerprint-resistant exterior

Installation

Unpack and inspect contents. Remove all packaging materials and tape.

  1. Position refrigerator: Allow at least 1 inch clearance on sides and top, 2 inches at back for ventilation.
  2. Level refrigerator: Adjust front leveling legs to ensure doors close properly.
  3. Connect water line: Shut off water supply; connect 1/4-inch copper tubing to cold water line and refrigerator inlet.
  4. Plug into dedicated 115V, 60Hz, 15-amp grounded outlet.
  5. Allow 24 hours for cooling before adding food.

WARNING! Refrigerator is heavy; use two people to move. Ensure water line connections are tight to prevent leaks.

First-Time Setup

Plug in refrigerator; follow initial setup steps.

  1. Set temperatures: Press TEMPERATURE buttons to set refrigerator to 37°F (3°C) and freezer to 0°F (-18°C).
  2. Flush water system: Dispense and discard first 2 gallons of water to clear air from lines.
  3. Activate ice maker: Lift wire signal arm to ON position; first batch of ice may take 24 hours.
  4. Reset filter indicator: Press and hold FILTER RESET button for 3 seconds after installing new filter.

CAUTION! Do not use mechanical devices or sharp instruments to defrost freezer.

Specifications

Controls and Settings

Control panel located on refrigerator door exterior.

Buttons: TEMPERATURE (Fridge/Freezer), ICE TYPE (Cubed/Crushed), LOCK (dispenser lock), FILTER RESET, ENERGY SAVER, DOOR ALARM.

Temperature Settings: Refrigerator (34°F to 46°F), Freezer (-5°F to 5°F). Ice Type: Select cubed or crushed ice. Dispenser Lock: Press and hold LOCK for 3 seconds to disable dispenser. Filter Reset: Hold for 3 seconds after filter replacement. Energy Saver: Reduces condensation in humid environments. Door Alarm: Sounds after 3 minutes if door is ajar.

Connecting Water Line

Required for ice maker and water dispenser operation.

  1. Turn off main water supply.
  2. Connect 1/4-inch copper tubing from cold water line to refrigerator inlet valve.
  3. Turn on water supply and check for leaks.
  4. Flush system by dispensing water for 2 minutes.

Tip: Use a water line kit (part number 8212547) for proper connection.

Using Ice & Water Dispenser

Dispenses ice (cubed or crushed) and chilled water.

  1. Select ice type: Press ICE TYPE button for cubed or crushed ice.
  2. Dispense ice: Press glass against ice dispenser paddle.
  3. Dispense water: Press glass against water dispenser paddle.
  4. Replace water filter: When FILTER indicator lights, replace WFC7500 filter.
  5. Clean dispenser area: Wipe with soft, damp cloth; do not use abrasive cleaners.

WARNING! Do not use with containers that are not sturdy enough to withstand dispensing force.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water for cleaning.

Exterior: Clean stainless steel with manufacturer-recommended cleaner. Interior: Remove shelves and bins; wash with warm, soapy water. Condenser coils: Vacuum every 6 months for efficiency. Door seals: Wipe with damp cloth to maintain seal.

CAUTION! Do not use abrasive cleaners, ammonia, or bleach on stainless steel surfaces.

Energy Saving Tips

Regulatory Information

UL Listed. Meets NSF/ANSI Standard 7 for commercial refrigerators. Energy Star certified. For support, visit www.whirlpool.com or contact 1-800-253-1301. Copyright © Whirlpool Corporation. All trademarks owned by Whirlpool, U.S.A.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower/controlsEnsure unit is plugged in; check circuit breaker; verify temperature settings.
Water dispenser not workingWater supply/filterCheck water supply valve; replace water filter; flush system.
Ice maker not producing iceSignal arm/filterEnsure signal arm is in down position; check water filter; allow 24 hours for initial batch.
Excessive frost in freezerDoor seal/temperatureCheck door seal for gaps; ensure door closes completely; verify temperature setting.
Dispenser leakingGlass alignment/connectionsEnsure glass is centered under dispenser; check water line connections.
Unusual noisesLeveling/fanLevel refrigerator; check for obstructions in fan or condenser area.

Reset: Unplug for 5 minutes, then plug back in to reset control board.

Service: 1-800-253-1301; www.whirlpool.com

Whirlpool Model WRS321SDHW01 Manual © - All Rights Reserved 2025