whirlpool model wrf736sdam14 manual

The Whirlpool WRF736SDAM14 is a 36-inch French Door Refrigerator with a capacity of 25.5 cubic feet, featuring an external ice and water dispenser, fingerprint-resistant stainless steel finish, adaptive defrost system, dual evaporators, adjustable gallon door bins, humidity-controlled crispers, LED lighting, and a factory-set temperature of 37°F for the refrigerator and 0°F for the freezer. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Using the Ice & Water Dispenser 7. Food Storage Organization 8. Care & Cleaning 9. Energy Saving Tips 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: French doors, external ice and water dispenser, dual cooling system, adjustable shelves, humidity-controlled crispers, freezer drawers, and electronic controls.

FeatureDescription
External DispenserProvides ice (crushed/cubed) and chilled water
Fingerprint-Resistant FinishStainless steel exterior that resists smudges
Dual EvaporatorsSeparate cooling systems for fridge and freezer to prevent odor transfer
Adaptive DefrostSystem adjusts defrost cycles based on usage to save energy
Adjustable Gallon Door BinsCan hold large containers like milk jugs
Humidity-Controlled CrispersPreserve freshness of fruits and vegetables
LED LightingEnergy-efficient interior lighting
Factory Set TemperaturesRefrigerator: 37°F (3°C); Freezer: 0°F (-18°C)
Door AlarmSounds if refrigerator or freezer door is left open
Ice MakerAutomatic ice maker located in the freezer

Installation

Unpack and inspect contents. Ensure location meets requirements.

  1. Remove packaging and tape: Remove all shipping materials, including base grille tape.
  2. Level the refrigerator: Adjust the front leveling legs so the refrigerator is stable and doors close easily.
  3. Connect to water supply: Connect a 1/4" copper water line to the refrigerator's water valve. Ensure the water supply provides 20-120 psi.
  4. Plug into dedicated outlet: Use a properly grounded 115V, 60Hz, 15- or 20-amp circuit.
  5. Allow space for ventilation: Leave at least 1" of space on the sides and back, and 2" above the unit.

WARNING! The refrigerator is heavy; use two people to move it. Do not install near a heat source.

First-Time Setup

After installation, allow the refrigerator to cool for 24 hours before adding food.

  1. Power on: Plug in the refrigerator. The interior lights and control panel should illuminate.
  2. Set temperatures: The default settings are recommended. Use the control panel to adjust if needed.
  3. Start the ice maker: Lift the wire signal arm to the "ON" (up) position. Discard the first batch of ice (about 24 cubes).
  4. Fill the water system: Flush the system by dispensing water for 3 minutes to clear air from the lines.
  5. Organize shelves and bins: Adjust shelves and door bins to suit your storage needs.

CAUTION! Do not load food until the refrigerator has reached safe temperatures.

Specifications

Controls and Settings

The control panel is located on the exterior dispenser panel.

Buttons/Functions: LOCK (press and hold for 3 seconds to lock/unlock controls), TEMPERATURE (adjust fridge/freezer temp), ICE TYPE (select cubed or crushed), FILTER RESET (reset after changing water filter), LIGHT (turns interior lights on/off).

Temperature Settings: Use the TEMPERATURE button to cycle through options. Refrigerator range: 33°F to 45°F. Freezer range: -5°F to 5°F. The "Cooling Off" mode turns off cooling for cleaning.

Door Alarm: Sounds if either door is open for more than 5 minutes. Press any button to silence.

Using the Ice & Water Dispenser

  1. Select ice type: Press the ICE TYPE button to choose between cubed or crushed ice.
  2. Dispense ice: Press a glass against the ice paddle. Release to stop.
  3. Dispense water: Press a glass against the water paddle. Release to stop.
  4. Replace water filter: When the FILTER status light turns red, replace the EveryDrop® filter. Press and hold FILTER RESET for 3 seconds to reset.

Tip: For first use or after filter replacement, flush the system by dispensing 2 gallons of water.

WARNING! Do not use with non-potable water. Children should not play with the dispenser.

Food Storage Organization

For optimal freshness and energy efficiency:

Do not block air vents inside the refrigerator or freezer.

Care & Cleaning

Unplug the refrigerator before cleaning the interior.

  1. Exterior: Clean the stainless steel with a damp cloth and a mild detergent. Wipe in the direction of the grain.
  2. Interior: Use a solution of baking soda and warm water (2 tbsp per quart). Do not use abrasive cleaners.
  3. Shelves and Bins: Remove and wash with warm, soapy water. Dry thoroughly before replacing.
  4. Dispenser Area: Wipe with a soft, damp cloth. Clean the ice chute periodically.
  5. Condenser Coils: Vacuum the coils at the base or rear every 6-12 months for efficiency.

CAUTION! Never use harsh chemicals, ammonia, or steel wool on any surface.

Energy Saving Tips

Regulatory Information

This appliance complies with Part 15 of the FCC Rules. Operation is subject to the condition that it does not cause harmful interference. Copyright © Whirlpool Corporation. All rights reserved. Whirlpool is a trademark of Whirlpool, U.S.A. For support, visit www.whirlpool.com or contact 1-800-253-1301.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator is not coolingPower issue, door ajar, temp settingCheck power cord and outlet; ensure door is closed; verify temperature settings.
Dispenser not workingWater supply, filter, lock modeCheck water valve is on; replace water filter; ensure control panel is not locked.
Ice maker not making iceSignal arm, water line, freezer tempEnsure signal arm is in the ON position; check water line connection; freezer must be at 0°F.
Water dispenser is slowNew filter, kinked lineFlush new filter for 2 gallons; check for kinks in the water line.
Unusual noiseLeveling, items touching back wallEnsure refrigerator is level; check if containers are vibrating against the back.
Interior lights not workingLight switch, LED failureCheck if door is pressing the light switch; contact service for LED replacement.

Reset: Unplug the refrigerator for 5 minutes, then plug it back in.

Service: 1-800-253-1301; www.whirlpool.com

Whirlpool Model WRF736SDAM14 User Manual © - All Rights Reserved 2025