Whirlpool Gold Series Dishwasher Manual 2007

The Whirlpool Gold Series Dishwasher (2007 model) is a high-performance built-in dishwasher featuring multiple wash cycles, energy-saving options, adjustable racks, soil sensors, and quiet operation. This manual covers essential information for safe installation, daily operation, cycle selection, maintenance, and troubleshooting of your appliance. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control Panel, Upper and Lower Racks, Silverware Basket, Filter System, Wash Arms, Detergent and Rinse Aid Dispensers.

Installation

Unpack and inspect contents. Ensure proper electrical and plumbing connections.

1. Location: Install under counter in a level, sturdy location near water, drain, and power supply.
2. Water Connection: Connect hot water supply line (120°F/49°C recommended) to inlet valve.
3. Drain Connection: Connect drain hose to sink drain or garbage disposal using high-loop or air gap method.
4. Electrical: Plug into grounded 120V, 60Hz outlet (dedicated circuit recommended).
5. Leveling: Adjust leveling legs so dishwasher is level front to back and side to side.

WARNING! Installation must comply with local codes. Disconnect power before servicing. Use two people for handling.

First-Time Setup

Before first use, run a complete cycle to clean the interior.

1. Remove shipping materials: Check interior for any packing blocks or tape.
2. Load detergent: Fill main detergent cup with a measured amount of dishwasher detergent.
3. Fill rinse aid: Open rinse aid dispenser and fill to MAX line with rinse aid liquid.
4. Run a rinse cycle: Select the Rinse Only cycle and start to flush the system.
5. Set water hardness: Adjust the rinse aid dispenser setting based on your local water hardness.

CAUTION! Use only detergents and rinse aids designed for automatic dishwashers.

Specifications

• Model Series: Whirlpool Gold Series (2007).
• Type: Built-in undercounter dishwasher.
• Capacity: Standard place settings for 12.
• Water Connection: Hot water supply (120°F/49°C recommended).
• Electrical: 120V AC, 60Hz, 15 Amp (dedicated circuit recommended).
• Water Pressure: 20-120 psi.
• Noise Level: Quiet operation design.
• Dimensions: Standard 24-inch width undercounter.
• Warranty: 1-year limited parts and labor.

Controls and Settings

Access controls via the electronic touchpad on the top front of the door.

Cycles: NORMAL (for everyday loads), HEAVY (for pots/pans), LIGHT (for lightly soiled), RINSE ONLY (for rinsing hold), CHINA/CRYSTAL (gentle wash).

Options: HEATED DRY (on/off), HI-TEMP WASH (boosts water temp), SANI RINSE (final rinse at higher temp), DELAY START (1-12 hours), CHILD LOCK (press and hold for 3 seconds).

Status Indicators: Cycle Progress lights, Clean light, Heated Dry light, Delay Start countdown.

Loading the Dishwasher

Proper loading ensures optimal cleaning and drying.

1. Scrape off large food particles; pre-rinsing is not required.
2. Lower Rack: Place plates, pots, pans, and larger items facing center.
3. Upper Rack: Place glasses, cups, bowls, and plastic items. Rack can be adjusted up/down.
4. Silverware Basket: Place utensils with handles down (except knives) mixed for best cleaning.
5. Ensure items do not block spray arms or detergent dispenser.

Tip: Refer to the loading guide inside the door for specific item placement.

Cycle Selection & Operation

Select cycle based on soil level and item type.

1. Add Detergent: Fill main detergent cup only. Use a measured amount (check detergent instructions).
2. Add Rinse Aid: Ensure dispenser is filled. Adjust setting (1-6) based on water hardness.
3. Select Cycle: Press the desired cycle button (NORMAL, HEAVY, etc.).
4. Select Options: Press desired option buttons (e.g., HEATED DRY, HI-TEMP WASH).
5. Start: Close door firmly and press START. The cycle will begin.
6. Delay Start: Press DELAY START, then use +/- to set hours, then press START.

WARNING! Do not use hand soap or laundry detergent. Use only automatic dishwasher detergent.

Care & Cleaning

Regular maintenance ensures performance and longevity.

1. Exterior: Wipe with soft, damp cloth. Use mild detergent if needed. Do not use abrasive cleaners.
2. Interior: Periodically check and clean the filter assembly at the bottom of the tub.
3. Spray Arms: Check for clogs in spray arm holes and clear if necessary.
4. Door Gasket: Wipe clean to remove food or detergent residue.
5. Monthly Cleaning: Run a cycle with a dishwasher cleaner or a cup of vinegar placed on the top rack.

CAUTION! Unplug or disconnect power before any maintenance. Do not use steel wool or harsh abrasives.

Regulatory Information

This appliance complies with FCC Part 15 for unintentional radiators. Manufactured under one or more U.S. Patents. Copyright © 2007 Whirlpool Corporation. All rights reserved. Whirlpool is a registered trademark of Whirlpool, U.S.A. For support, visit www.whirlpool.com or contact 1-800-253-1301.

Troubleshooting

Reset: Turn power off at circuit breaker for 1 minute, then restore power.

Service: 1-800-253-1301; www.whirlpool.com