manual for whirlpool wrs321sdhz01

The Whirlpool WRS321SDHZ01 is a 21.6 cubic foot side-by-side refrigerator with fingerprint-resistant stainless steel exterior, factory-installed ice maker, adjustable gallon-deep door bins, LED lighting, electronic temperature controls, and energy-efficient design. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Line 7. Using the Ice Maker 8. Care & Cleaning 9. Energy Saving Tips 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Side-by-side doors, factory-installed ice maker, adjustable door bins, LED interior lighting, electronic controls, water filter.

Feature	Description
Fingerprint-resistant finish	Stainless steel exterior that resists smudges
Factory-installed ice maker	Produces ice automatically when connected to water
Adjustable door bins	Bins can be repositioned to accommodate tall items
LED lighting	Energy-efficient interior lighting
Electronic temperature controls	Digital controls for refrigerator and freezer compartments
Water filter	Reduces impurities in water and ice
Spill-proof glass shelves	Contain spills for easy cleanup
Humidity-controlled crispers	Preserve freshness of fruits and vegetables
Freezer baskets	Organize frozen food items
Energy Star certified	Meets energy efficiency guidelines

Installation

Unpack and inspect contents. Remove all packaging materials and tape.

Position refrigerator: Allow at least 1 inch clearance on sides and top, 2 inches at back for ventilation.
Level the refrigerator: Adjust front leveling legs to ensure doors close properly.
Connect water line: Use 1/4-inch copper tubing or approved water supply kit.
Plug into dedicated 115V, 60Hz AC outlet with proper grounding.

WARNING! Do not install near heat sources. Ensure floor can support refrigerator weight.

First-Time Setup

After installation, allow refrigerator to cool for 24 hours before adding food.

Set temperatures: Recommended settings are 37°F for refrigerator, 0°F for freezer.
Install water filter: Remove protective cap and install filter by turning clockwise.
Flush water system: Run water through dispenser for 3 minutes to clear air and particles.
Activate ice maker: Lift signal arm to ON position.

CAUTION! Do not overload refrigerator. Allow space for air circulation.

Specifications

Capacity: 21.6 cubic feet total (14.3 cu ft refrigerator, 7.3 cu ft freezer).
Dimensions: 32-7/8" wide x 66-1/4" high x 33-1/2" deep.
Finish: Fingerprint-resistant stainless steel.
Ice Maker: Factory-installed, produces up to 10 lbs of ice per day.
Water Filter: EveryDrop Filter 4 (EDR4RXD1).
Lighting: LED interior lighting.
Shelves: 4 adjustable tempered glass shelves.
Power: 115V, 60Hz, 7.5 amps.
Annual Energy Use: 592 kWh.

Controls and Settings

Electronic controls located inside refrigerator compartment.

Temperature Controls: Refrigerator (34°F to 46°F), Freezer (-5°F to 5°F).

Special Features: Sabbath Mode (disables interior lights and alarms), Control Lock (prevents accidental setting changes), Filter Reset (indicator light reset after filter replacement).

Display Indicators: Water filter status, door ajar alarm, temperature display.

Connecting Water Line

Required for ice maker and water dispenser operation.

Turn off main water supply.
Connect 1/4-inch copper tubing to cold water line using saddle valve or tee fitting.
Route tubing to refrigerator connection at bottom rear.
Connect tubing to refrigerator inlet valve.
Turn on water and check for leaks.

Tip: Use only drinking water quality tubing approved for refrigerator use.

Using the Ice Maker

Automatic ice production when connected to water supply.

Activation: Ensure signal arm is in down (ON) position.
First batch: Takes approximately 24 hours to produce first ice.
Storage: Ice bucket holds approximately 4 lbs of ice.
Shut-off: Ice maker automatically stops when bucket is full.
Manual off: Lift signal arm to stop ice production.

WARNING! Do not use with non-potable water sources. Replace water filter every 6 months.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and warm water for cleaning.

Exterior: Clean with stainless steel cleaner and soft cloth. Wipe in direction of grain.

Interior: Remove shelves and bins for thorough cleaning. Dry completely before replacing.

Condenser coils: Vacuum every 6 months for efficient operation.

CAUTION! Do not use abrasive cleaners or sharp objects that could damage surfaces.

Energy Saving Tips

Maintain proper temperatures (37°F refrigerator, 0°F freezer).
Ensure door seals are clean and tight.
Allow hot foods to cool before refrigerating.
Keep condenser coils clean.
Minimize door openings.
Ensure adequate ventilation around refrigerator.

Regulatory Information

UL listed. Meets Department of Energy energy conservation standards. California Proposition 65 Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For support, visit www.whirlpool.com or contact 1-800-253-1301.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Refrigerator not cooling	Power/controls	Check power cord; ensure controls set correctly; allow 24 hours for initial cooling.
Ice maker not working	Water supply/arm position	Ensure water connected; signal arm down; wait 24 hours for first ice.
Water dispenser slow	Filter/kink in line	Replace water filter; check for kinks in water line.
Excessive frost in freezer	Door seal/warm food	Check door seal; ensure door closes completely; avoid placing warm food in freezer.
Noisy operation	Leveling/items touching	Level refrigerator; ensure items not touching interior walls.

Reset: Unplug for 5 minutes to reset electronic controls.

Service: 1-800-253-1301; www.whirlpool.com